EA3500 – D&C

Cisco Linksys EA3500 OpenWrt Snapshot镜像

src/gz designated_driver_base http://hk.boweihe.me/downloads.openwrt.org/snapshots/trunk/kirkwood/generic/packages/base src/gz designated_driver_kernel http://hk.boweihe.me/downloads.openwrt.org/snapshots/trunk/kirkwood/generic/packages/kernel src/gz designated_driver_luci http://hk.boweihe.me/downloads.openwrt.org/snapshots/trunk/kirkwood/generic/packages/luci src/gz designated_driver_management http://hk.boweihe.me/downloads.openwrt.org/snapshots/trunk/kirkwood/generic/packages/management src/gz designated_driver_packages http://hk.boweihe.me/downloads.openwrt.org/snapshots/trunk/kirkwood/generic/packages/packages src/gz designated_driver_routing http://hk.boweihe.me/downloads.openwrt.org/snapshots/trunk/kirkwood/generic/packages/routing src/gz designated_driver_telephony http://hk.boweihe.me/downloads.openwrt.org/snapshots/trunk/kirkwood/generic/packages/telephony # src/gz designated_driver_targets http://hk.boweihe.me/downloads.openwrt.org/snapshots/trunk/kirkwood/generic/packages/targets

Cisco Linksys EA3500 刷入OpenWrt

万万没想到这个路由器现在也有了官方的OpenWrt支持！
可以参考这里（英文）：https://wiki.openwrt.org/toh/linksys/ea3500
大致翻译如下：

As of r47458 the EA3500 is completely supported. This model is identified by the board codename “Audi.”
自从版本r47458开始，EA3500已被OpenWrt完整支持了。这个机型的固件可以用识别码 “Audi”查找

访问这里可以得到最新的编译版本：https://downloads.openwrt.org/snapshots/trunk/kirkwood/generic/
需要查找带有

openwrt-kirkwood-linksys-audi-squashfs-factory.bin

字样的，是可以直接用思科原版固件刷入的；而

openwrt-kirkwood-linksys-audi-squashfs-sysupgrade.tar

是从旧版本OpenWrt升级用的。
注意：刷好之后默认没有开启无线的，也没有装luci图形界面，需要用ssh(可通过putty软件)用有线的方式连接到管理界面。路由器默认的IP地址应该是192.168.1.1
连接SSH时，默认用户是root，然后是空密码。进入后需要用

passwd

命令设置密码。
然后可以更新opkg包进而安装网页管理界面luci

opkg update #更新包信息
opkg install luci #下载并安装luci
opkg install luci-i18n-base-zh-cn #可选，安装中文语言

随后就能通过网页访问http://192.168.1.1来管理啦！